Question: How To Install Aluminum Fence On Concrete?

Should aluminum fence posts be set in concrete?

You tend to get a better long-term result by setting the fence posts in concrete as opposed to gravel. When setting fence posts in concrete, it’s best to let the concrete dry for three or four days before attaching your fence rails, panels or pickets.

Can you put a fence on concrete?

When installing a fence on an existing concrete pad, some fence installers prefer to core drill through the concrete and set posts the traditional way – embedded in concrete underground. Using a rented core drill, you can drill a hole through your concrete slab for each fence post.

Should fence posts be set in concrete?

Concrete is the most secure material for setting fence posts, especially if you have sandy soil. Using premixed concrete rather than dry concrete will ensure ultimate security. While concrete is sturdy, it lacks the drainage of gravel and can trap moisture, ultimately leading to rot.

Can you put aluminum posts in concrete?

Aluminum reacts with the alkalis (OH) found in portland cement concrete. When these two chemicals are combined, the reaction produces hydrogen gas. First, a significant corrosion of aluminum embedded in concrete can occur. The corrosion can cause expansion of the concrete and subsequent cracking of hardened concrete.

You might be interested:  Often asked: Removing Vinyl Tile From Concrete Floor?

How do you keep fence posts from rotting in concrete?

Consider Adding Posts to Concrete



From here, you should fill the hole with about 6 inches of gravel. This will prevent rotting by ensuring that the post is kept dry when water makes its way into the soil. Place the post in the gravel, then fill with a batch of cement until it reaches the top of the hole.

How much concrete do I need for aluminum fence post?

Most fence post holes will need between 1 – 4 bags of concrete to securely hold the post in place. The best way to determine the size of the hole is: Diameter of the hole is 3 times the width of the fence post. Depth of the hole is one-third to half the above ground height of the fence post.

How do you attach something to concrete without drilling?

A simple fix might include an adhesive or adhesive-baked hook, while there are other fasteners like hard wall hooks and masonry nails. Powder-actuated fasteners and concrete nail guns are useful for supporting frames and providing a much greater hold.

Should you attach a fence to your house?

Don’t attach the fence to the house. Aside from putting holes in your siding (not a good thing), your fence and your house will most likely move differentially. The attachment could result in a tear of the siding, which would be a bad thing.

How do you attach a concrete post base?

How to Attach Deck Post Bases to Concrete Footers

  1. Hold your drill plumb. Use a drill with a hammer drill bit to install a concrete sleeve anchor into the center of the concrete footing.
  2. Don’t over tighten the bolt.
  3. Place your foot behind the post when nailing.
You might be interested:  Question: How To Resurface Worn Concrete?

How do I bolt something to concrete?

Simply drill a hole into the concrete, hold the fixture you’re fastening over the hole, then use a hammer to tap the anchor into the hole. As you drive in the pin, the sleeve expands outward, trapping the anchor in the hole.

Leave a Reply

Your email address will not be published. Required fields are marked *