Quick Answer: How To Lay Hardwood On Concrete?

Can you put hardwood on concrete?

Solid parquet hardwood flooring can be glued directly to a concrete slab on grade or above grade with the use of a manufacturer recommended vapor retarder. Solid parquet should not be installed below grade. Successful installation also requires conducting a concrete slab moisture test before parquet installation.

Do you need underlay for solid wood flooring on concrete?

Because you are likely to be fixing your solid wood boards to the subfloor, underlay is not usually used, but there are slatted underlays you can buy for the purpose, with pre-cut slots that allow the floor to be glued directly to the subfloor (try Acoustalay Slatted Glue Through Underlay, available from Screwfix).

What is the best type of wood flooring to put over concrete?

A floating floor is the perfect companion for a concrete subfloor. According to flooring experts, the best kind of wood flooring to use with a concrete subfloor is a floating engineered wood floor. This kind of floor performs well, resists moisture and is easy to install.

You might be interested:  Often asked: How To Get Mildew Off Concrete?

Do I need a vapor barrier between concrete and wood flooring?

Do I need a vapor barrier for hardwood floors?” The answer is YES! Moisture can destroy hardwood flooring. It causes cupping, warping, and even mildew if not treated. You must install a moisture barrier to protect your flooring from water wicking up from below.

How do you prepare a concrete floor for hardwood?

Typically, the floor must be level and uniform within 3/16 inch every 10 feet. Check your wood flooring manufacturer’s recommendations and sand any high spots with a concrete grinder. Fill any low spots with a cementitious leveling compound following the manufacturer’s directions and allow it to dry before proceeding.

Can you float a solid wood floor on concrete?

The quickest way to get new wood underfoot is to install a floating floor. Unlike traditional solidwood strips, a floating floor isn’t nailed down. Instead, the planks are either glued or snapped together. The planks go down fast, over virtually any material—concrete, plywood, sheet vinyl, even ceramic tile.

Can you lay pine flooring on concrete?

Yes, it can be done! For the longest time, homeowners were warned that wide plank wood floors installed over concrete would result in moisture problems.

What flooring can you put on concrete?

The best options for flooring over a concrete slab foundation are wood/laminate, carpet, or tile for your whole house. Many concrete floors have a tendency to get damp, so when you are installing wood floors over a concrete slab foundation there are some important things that you need to do.

You might be interested:  Often asked: How To Extend A Concrete Patio With Pavers?

Is concrete floor cheaper than wood?

It is possible for a “fancy” concrete floor to be more expensive than an economical hardwood floor. In general, a tight budget will find concrete floors more budget-friendly, but it depends on the design and finish of the concrete floor.

Can you put flooring over concrete?

Laminate flooring can be installed over concrete, wood or carpet subfloor or other surfaces. Installation of good quality underlayment is highly recommended. Installing underlayment is easy but it has to be done precise to avoid any tears.

What should I put between wood and concrete?

In most cases, either pressure-treated lumber or naturally durable lumber (defined by the IRC as the heartwood of redwood, cedar, black locust, and black walnut) is acceptable. In some cases, separating wood from concrete with a water-impervious membrane or vapor retarder is all that’s required.

Should I put plastic down before I pour concrete?

The plastic will help keep moisture from coming up, but also to keep the ground from sucking all the water from the concrete. If your contractor is good with concrete then he should have no problems with the finish with plastic.

Do you need a moisture barrier under concrete?

Water vapor will always move from a high relative humidity environment below the building into an area of low relative humidity – even through concrete. That’s why nearly every expert in the concrete industry recommends a belowslab vapor barrier to stop the vapor drive of water upward and into your building envelope.

Leave a Reply

Your email address will not be published. Required fields are marked *