- 1 What can I use for curved concrete forms?
- 2 What wood do you use for curved concrete forms?
- 3 How do you build a curved concrete wall?
- 4 Do you need gravel under concrete sidewalk?
- 5 Do you need rebar for 4 inch slab?
- 6 Can you pour concrete directly on dirt?
- 7 Is it OK if it rains after pouring concrete?
- 8 What do you use for concrete forms?
- 9 Can you build a fire pit on concrete patio?
- 10 How do I make a concrete patio?
- 11 Can you use OSB for concrete forms?
- 12 How do you build a small concrete wall?
What can I use for curved concrete forms?
Masonite siding has often been an option for forming curves — it’s stiff, yet bendable. Landscape edging material made out of metal is what some contractors use because it’s easy to find. “Kerfs” or grooves in two-by-fours allow the wood to bend, or rip thinner plywood to the desired height.
What wood do you use for curved concrete forms?
Hardboard is inexpensive form material and is easy to flex into smooth curves. Hardboard siding is intended for exterior walls, but it’s also great stuff for forming curves because it’s flexible and cheap.
How do you build a curved concrete wall?
A.: Forming curved surfaces can be accomplished by using plywood, which can be bent to the desired radius. However, the plywood must be thick enough to support the load, or pressure, of wet concrete yet thin enough to bend properly. Plywood can be bent two ways: the strong way and the weak way.
Do you need gravel under concrete sidewalk?
Whether you pour concrete for a walkway or patio, a strong gravel base is required to prevent the concrete from cracking and shifting. Gravel is especially important in clay soil because it doesn’t drain well, which results in water pooling under the concrete slab and slowly eroding the soil as it finally drains.
Do you need rebar for 4 inch slab?
No, you do not need rebar for a 4–inch slab of concrete on grade. A 4–inch-thick slab cast on the ground and in permanent contact with it will float and rebar is not required. Rebar is recommended on concrete measuring 5 – 6 inches thick.
Can you pour concrete directly on dirt?
Long story short, yes you can pour concrete over dirt.
Is it OK if it rains after pouring concrete?
Heavy rain can cause problems to freshly poured concrete as it can wash out some of the cement from the mix. This can weaken the surface of the concrete, making it a softer consistency and decreasing the strength of the concrete.
What do you use for concrete forms?
Wooden boards have always been the go-to choice for concrete forms. However, not just any boards will do. A contractor must carefully consider the dimensions of the wood they use, otherwise, the results may not meet expectations.
Can you build a fire pit on concrete patio?
Placing your fire pit on concrete is completely safe, but cracking might occur due to high temperatures. Taking the right steps before purchasing or installing a fire pit is your best defense against concrete damage.
How do I make a concrete patio?
How to Build a Concrete Patio
- Step 1: Lay Out and Excavate the Patio.
- Step 2: Drive Stakes Along the New Layout Lines.
- Step 3: Nail the First Form in Place.
- Step 4: Splice Boards Together, if Necessary.
- Step 5: Place the Mesh.
- Step 6: Pour the Concrete Into the Forms.
- Step 7: Flatten the Surface.
- Step 8: Round the Edges.
Can you use OSB for concrete forms?
Typically, both OSB and plywood can be used in concrete forms, but plywood is the best option for concrete forming applications. Plywood is the better choice; its structure doesn’t unravel following constant exposure to water.
How do you build a small concrete wall?
Once your concrete footing that will support your homemade wall is complete, you can follow these steps to form the wall.
- Measure for the wall.
- Place nails at least 8 feet apart.
- Nail a 2-by-4 to the concrete footing.
- Cut plywood.
- Cut some 2-by-4s.
- Nail the plywood to the 2-by-4.
- Use a level.
- Repeat on the other side.