- 1 Are concrete fence posts easy to remove?
- 2 How do you remove concrete footings?
- 3 How do you replace a concrete fence post?
- 4 Will fence posts rot in concrete?
- 5 How do you straighten a concrete fence post without removing it?
- 6 How do you remove old concrete posts?
- 7 What is the best concrete dissolver?
- 8 Will a hammer drill break up concrete?
- 9 How do you remove concrete?
- 10 Can you repair concrete fence posts?
- 11 When should I replace my fence post?
- 12 How long will treated posts last in concrete?
- 13 How long will pressure treated posts last in the ground?
- 14 Is 2 feet deep enough for fence posts?
Are concrete fence posts easy to remove?
Thinking a bit more about it, the easiest way to get mine out whole might have been to dig a hole/slot beside the post, tilt it into the hole then pivot/pull it up out of the ground over a log/fulcrum/roller at the end of the slot using the weight of the long post to counterbalance the concrete slug on the end.
How do you remove concrete footings?
Steps in Removing Concrete Deck Footings
Using a spade shovel manually excavate around the footing at least 3/4 the way around and at least 2/3rds of the length of the footing. Dig until you see the footing wiggle a bit. The more you dig the easier the footing will come out.
How do you replace a concrete fence post?
Dig a hole around 1 side of the fence post.
With a shovel, break into the ground surrounding the fence post’s concrete base. Keep digging until you create a half-circle gap between the ground and concrete. If possible, dig a hole that is as deep as the concrete itself, giving the post as much wiggle room as possible.
Will fence posts rot in concrete?
A: Actually, your point is well taken. Simply setting the posts in concrete does create a condition that will accelerate rot in the bottom of the posts. With pressure-treated posts, the rot will be slow. The concrete at the top should be sloped away from the post to grade level to avoid water pooling around the base.
How do you straighten a concrete fence post without removing it?
The Fix-A-Fence Solution
- Step 1 – Prepare the Site.
- Step 2 – Prepare the Fix-a-Fence Kit.
- Step 3 – Position the Bracket in the Hole.
- Step 4 – Mix a 60lb Bag of Concrete.
- Step 5 – Fill the Hole with Concrete.
- Step 6 – Take a Break While the Concrete Cures.
- Step 7 – Reposition the Fence Post and Attach the Bracket.
How do you remove old concrete posts?
Dig the Post Out by Hand
There are a few ways to make this task a little easier. One of the best methods for digging out fence posts by hand is to only remove the dirt around one “face” of the fence post. By digging slightly deeper than the base of the concrete, you can then tip the post into the hole and lift it out.
What is the best concrete dissolver?
Sakrete Concrete Dissolver is a safe, environmentally-friendly liquid alternative to aggressive acid concrete removers. Concrete Dissolver can be used to remove dried on cement, concrete, mortar, or stucco from most surfaces.
Will a hammer drill break up concrete?
Hammer drills do not have a chiseling function and can be used to drill into a variety of materials. Rotary hammers use an electro-pneumatic hammer piston to generate high impact energy, which allows it to drill or demolish concrete.
How do you remove concrete?
Steps for Removing a Concrete Slab
- Step 1: Create a Void Under the Concrete. The best way to speed up concrete removal is to create a void underneath the section of slab you’re working on.
- Step 2: It’s Hammer Time.
- Step 3: Pull Apart and Remove the Broken Concrete.
- Step 4: Repeat Steps Until Concrete Is Demolished.
Can you repair concrete fence posts?
You can get an epoxy-based repair mortar, probably Screwfix or similar. Never used it. ISTR that epoxy-based flooring required careful preparation of the old screed to ensure it stayed stuck. I suspect it’d cost more than a new post and I doubt that it will stay repaired for long.
When should I replace my fence post?
Depending on how badly they are damaged, some fence posts will pull right out of the ground. If the wood crumbles in your hands or the rot or termite damage covers more than about 30% of the post, you will need to replace the entire post.
How long will treated posts last in concrete?
A PT post will last a long time in concrete, maybe 5 to 10 years in soil alone. I suggest you embed the post in concrete, trowel a peak around the post so water runs off, and don’t let the PT post come in contact with the ground.
How long will pressure treated posts last in the ground?
3) A deck built with pressure treated wood will last a long time. Promotional literature promises lifelong performance for pressure treated wood. The Forest Products Laboratory and other research groups have shown that treated wood stakes placed in the ground for more than 40 years remain rot-free.
Is 2 feet deep enough for fence posts?
The depth of the hole should be 1/3-1/2 the post height above ground (i.e., a 6-foot tall fence would require a hole depth of at least 2 feet).