Readers ask: What Does A Yard Of Concrete Cover?

How many yards of concrete do I need for a 10×10 slab?

10 x 10 = 100 square feet. 4 ÷ 12 =.33. 100 x.33 = 33 cubic feet. 33 x.037 = 1.22 cubic yards.

How do you figure a yard of concrete?

How do I calculate how much concrete I need for a slab?

  1. Measure the area in feet.
  2. Multiply length by width, and then by thickness.
  3. Divide the resulting number by 27 to find cubic yards.

How many 80 pound bags of concrete is in a yard?

how many 80lb bags of concrete are in a yard? You will need 45 bags of concrete mix to make a cubic yard of concrete. There’s 27 cubic feet of concrete in a cubic yard.

How many 80lb bags of concrete do I need for 3 yards?

An 80# bag of pre-mixed cement, sand and gravel (CONCRETE) is 0.6 cubic foot per the bag. There are 27 cubic feet in a cubic yard. So 27 / 0.6 = 45 80# bags.

You might be interested:  Quick Answer: How To Remove Paint From Concrete Pavers?

Do you need rebar for 4 inch slab?

No, you do not need rebar for a 4inch slab of concrete on grade. A 4inch-thick slab cast on the ground and in permanent contact with it will float and rebar is not required. Rebar is recommended on concrete measuring 5 – 6 inches thick.

How many bags of concrete makes a yard?

On average, it will take 90 40lb bags, 60 60lb bags, or 45 80lb bags to fill one cubic yard of concrete.

How many bags of concrete do I need for a 10×20 slab?

A 60-pound bag yields. 017 cubic yards, and an 80-pound bag yields. 022 cubic yards. For a 10 x 10 slab, you would need 77 60-pound bags or 60 80-pound bags.

How much does it cost for a 12×12 concrete slab?

How much does a 12×12 concrete slab cost? The average cost to pour a 12×12 concrete slab that is 4” thick is between $888 and $1,584, with professional labor and materials included.

How much is 4 yards of concrete cost?

Each cubic yard of concrete costs $119 to $147 per cubic yard delivered.

Short-Load Concrete Prices.

Cubic Yards Mixing On-site Fees
4 – 4.75 $80
3 – 3.75 $90
2 – 2.75 $100
1 – 1.75 $110

How many bags of cement do I need for 1 cubic yard?

Pure cement, sand and crushed rock all have about the same density, so a block of pure cement measuring 1 cubic yard of volume (about 3,600 pounds) will contain 45 bags of cement.

How many wheelbarrows is a yard of concrete?

Wheelbarrow Conversions

Depending upon your wheelbarrow size (i.e. 2 or 3 cubic feet per wheelbarrow load), it will take 9 to 14 full loads to equal 1 cubic yard. The chart below shows how many full wheelbarrow loads it takes to equal the specified number of cubic yards.

You might be interested:  FAQ: How To Fix Stamped Concrete Color?

How many bags of concrete do I need for a post hole?

Mix two 50lb bags of concrete with water in a mixing tub or 5-gallon bucket. Add concrete into the hole and around the 4” x 4”. Depending on your climate, let concrete set up for 24 – 48 hours.

Is it cheaper to mix your own concrete?

One of the least expensive ways to get concrete is to mix your own. You can buy bags of the mix from a home improvement store. Typically, you only have to add water for it to be ready to pour. Otherwise, you risk getting a weaker concrete once it cures, which could lead to cracks or crumbles within a couple of years.

How much area does a 50 lb bag of quikrete cover?

One 50-pound bag of Quikrete Fast Setting Concrete Mix yields about. 375 cubic feet. For example, if you need to cover 33.333 cubic feet, using 60-pound bags of concrete, divide 33.333 cubic feet by. 45 cubic feet to get 74.07 total bags of concrete.

How thick should a concrete driveway be?

As for thickness, non-reinforced pavement four inches thick is standard for passenger car driveways. For heavier vehicles, a thickness of five inches is recommended. To eliminate standing water, the driveway should be sloped towards the street a minimum of one percent, or 1/8 inch per foot, for proper drainage.

Leave a Reply

Your email address will not be published. Required fields are marked *